Answered Plainly
Display: Text size:

Leer esta guía en español

Lawn Mower Won't Start — The Checks, in Order

Short answer: Start with the fuel. Briggs & Stratton, the company that makes most small mower engines, says it plainly: "Stale fuel, dirt, and debris are the most common cause of outdoor power equipment not starting or running properly." Gas that has not been treated with stabilizer begins to break down after about a month — so last season's gas, or even last month's, is the first suspect. After fuel, the maker's order is the spark plug, the air filter, and whether fuel is reaching the engine at all.

General information only — not a substitute for your mower's operator's manual or a service dealer's judgment about your engine. Briggs & Stratton's own first word on any of this: always refer to the operator's manual before starting any maintenance project on your equipment, and if you are unsure about a repair, see an authorized dealer.

This page stays at the outside checks. Fuel, plug, filter — the things the maker lists for owners. The inside of the carburetor and the engine's valves are dealer work, and the page stops where the maker stops.

The checks, in the maker's order

  1. Is there gas in it at all? Briggs & Stratton puts this first and does not apologize for it: many owners hit this frustration for one very obvious reason — the gas tank is empty. Check before you diagnose anything.
  2. Is the gas old? If you have last season's gas in the mower, drain the fuel tank and fill it with fresh gas. The maker's fuller version: drain the gas — including the gas sitting in the carburetor's float bowl — and replace it with fresh gas and fuel stabilizer. Untreated gas begins to break down after about a month, and stale fuel is the single most common cause on the maker's list.
  3. Check the spark plug. A loose, dirty, or disconnected spark plug is next on the maker's list. Check it, clean off any debris, reconnect it, and tighten it. Disconnected, dirty, or fouled spark plugs are common causes of engines that will not start.
  4. Check the air filter. A dirty air filter chokes the engine's air supply. Clean it or replace it — the maker's troubleshooting list puts a dirty filter behind no-starts and behind power lost mid-mow as well.
  5. Is fuel reaching the engine? Briggs & Stratton's own field check: tap the side of the carburetor to help the flow of gas. If that does not work, you might need a new fuel filter.

A habit the maker asks for every time

While you are standing there: Briggs & Stratton recommends checking the oil level and the oil's appearance while the engine is cold, and lists "every use" as the rhythm for that check. It is preventative care, not a starting fix — but a mower checked this way gives its warnings early, in the driveway, instead of mid-lawn.

If the starter rope is hard to pull

That is a different symptom with its own maker answer. A typical cause is the engine flywheel brake — the bar on the handle you hold down to run the engine — not being fully engaged: bring the bar all the way down to the handle before pulling. It can also happen if the blade is dragging in grass or clogged with clippings. The maker's method: move the mower off the lawn onto a hard surface, and with the mower turned off and the spark plug wire disengaged, clear the underside of excessive clippings, then try again. The plug wire comes off first — that ordering is the safety step, not a detail.

Stop lines — where the dealer takes over.

Ignition faults are dealer work. Briggs & Stratton lists ignition problems — a faulty spark plug lead, a shorted kill switch — among the causes of no-starts, and they are not owner checks. Neither is an improper spark plug gap's deeper cousin, the valves-and-compression check: the maker says those problems can cause hard starting or no start at all, that the test is a leak-down test, and that if you do not have one, you should see a dealer.

A carburetor that is dirty inside is not a tap-and-hope problem. The maker notes a dirty carburetor can cause poor performance or starting problems. Tapping the side to coax fuel flow is the owner's step; opening the carburetor up is not on this page.

Briggs & Stratton's own closing word: there are cases when special tools or skills are needed to make a fix, or home attempts are not doing the trick — and then it is time for a Briggs & Stratton service dealer. A mower that has failed all five checks above has reached that point.

Keeping it from happening next season

The maker's fuel guidance runs both ways: the same staleness that stops a spring start is prevented by the stabilizer habit — fresh gas with fuel stabilizer is what the drain-and-refill step calls for, and treated fuel is the difference between a mower that starts in March and one that gets this page read about it. The one-month breakdown clock on untreated gas is the number to remember.

General information only — not a substitute for your mower's operator's manual or a service dealer's judgment about your engine. If the engine smokes with light-colored smoke and will not keep running, Briggs & Stratton says that is time for a serious look by a professional — not another round of home checks. The maker's pages below are the whole basis of this page, and they are worth reading in the original.

Sources

Briggs & Stratton, "Small Engine Problem Solving Tips" (briggsandstratton.com): stale fuel, dirt, and debris are the most common cause of outdoor power equipment not starting or running properly; gasoline that has not been treated with fuel stabilizer begins to break down after about a month, after which the fuel should be drained — including draining the carburetor float bowl — and replaced with fresh gas and fuel stabilizer; check the oil level and appearance while the engine is cold, at every use; a dirty carburetor can cause poor performance or starting problems; disconnected, dirty, or fouled spark plugs are common causes for engines that will not start; improper spark plug gap can lead to poor performance; ignition problems include a faulty spark plug lead and a shorted kill switch; valves and compression problems can cause hard starting or no start, checked with a leak-down test — see a dealer if you do not have one; standing caution: read the engine and equipment manuals before servicing, and see an authorized dealer if unsure about a repair. Read in full November 7, 2026.

Briggs & Stratton, "Top 5 Mower Troubleshooting Tips" (briggsandstratton.com): always refer to the operator's manual before starting any maintenance project; a mower that won't start — check the gas tank is not empty; old gas leads to starting problems, so drain last season's gas and fill with fresh; a loose, dirty, or disconnected spark plug should be checked, cleaned of debris, reconnected, and tightened; a dirty air filter should be cleaned or replaced; if fuel is not reaching the engine, tap the side of the carburetor to help the flow of gas, and if that does not work a new fuel filter may be needed; a starter rope that is hard to pull is typically the engine flywheel brake bar not brought all the way down to the handle, or a blade dragging in grass or clogged with clippings — move the mower to a hard surface, and with the mower off and the spark plug wire disengaged, clear the underside; lighter colored smoke plus trouble keeping the mower running means a serious look by a professional; when special tools or skills are needed, or home attempts are not doing the trick, find a Briggs & Stratton service dealer. Read in full November 7, 2026.

Checked November 7, 2026.

Related guides: Washing Machine Won't Drain, Front-Load Washer Smells, Frozen Pipes, Furnace Blowing Cold Air and GFCI Outlet Keeps Tripping.