Dryer Takes Too Long to Dry — What to Check
General information only — not a substitute for a qualified service person's judgment about your dryer. This page explains what the federal safety agencies say and covers checks you can do from outside the machine.
This page stays outside the dryer. Nothing here opens the machine, touches a gas line, or takes a duct run apart inside a wall. Where the CPSC's own guidance hands a job to a qualified service person, this page says so and stops.
Why slow drying points at airflow
A dryer dries by moving heated air through the tumbling clothes and out of the house. Lint is the felt-like mat that comes off fabrics, and it collects in the screen, in the duct, and behind the machine. The CPSC explains the danger in one chain: lint can block the flow of air, cause excessive heat build-up, and result in a fire in some dryers. Blocked air explains both problems at once — the damp clothes in front of you, and the heat building up where you cannot see it.
That is why a dryer that has started taking two cycles deserves attention this week, not someday. The blockage causing the slow drying is the same blockage the fire statistics are about.
The checks, in order
- Clean the lint screen before or after every load. That is the CPSC's first instruction: clean the lint screen/filter before or after drying each load of clothes. A screen that looks clear can still be carrying a film of residue, but the habit that matters is the every-load cleaning — a neglected screen is the most common single blockage.
- Check the outside vent while the dryer is running. The CPSC: check the outside dryer vent while the dryer is operating to make sure exhaust air is escaping. Go outside, find the vent flap, and feel for a strong flow of warm air. If little or no air is coming out while the dryer runs, the vent or the exhaust duct is blocked.
- Clean the dryer vent and the exhaust duct. The CPSC says to clean them periodically. To remove a blockage in the exhaust path, the CPSC says it may be necessary to disconnect the exhaust duct from the dryer — and to remember to reconnect the ducting to the dryer and the outside vent before using the dryer again. Read the red box below before you move anything, especially with a gas dryer.
- Look at what the duct is made of. If your dryer connects to the wall with plastic or foil accordion-type ducting, the CPSC says to replace it with rigid or corrugated semi-rigid metal duct. Most manufacturers specify metal duct, the CPSC notes, because it provides maximum airflow; the flexible plastic or foil kind traps lint more easily and is more likely to kink or get crushed, which cuts the airflow down.
- Clean behind the dryer, and keep the area clear. Lint builds up behind the machine too, and the CPSC asks you to clean there and to keep the area around the dryer clean and free of clutter.
Stop lines — read before you move the dryer.
The inside of the dryer is a service person's job. The CPSC: have a qualified service person clean the interior of the dryer periodically, to keep lint from accumulating inside the machine. This page does not walk through opening a dryer, and neither should a video that skips the warning.
If your dryer runs on gas, do not move it or disconnect its duct yourself. Moving a gas dryer can disturb its gas connection. The vent check (step 2) and the lint screen are still yours to do; duct disconnection and reconnection on a gas dryer belong to a qualified service person.
Plug the dryer straight into the wall. The U.S. Fire Administration: always plug major appliances — refrigerators, stoves, washers and dryers — directly into a wall outlet. Never use an extension cord with a major appliance; the cord can overheat and start a fire.
Special care: clothes with anything flammable on them
The CPSC gives a separate warning for clothes soiled with volatile chemicals — such as gasoline, cooking oils, cleaning agents, or finishing oils and stains. Take special care with these loads:
- If possible, wash the clothing more than once to minimize the amount of chemical left on it, and preferably hang the clothes to dry.
- If you do use the dryer, use the lowest heat setting and a cycle with a cool-down period at the end.
- To keep clothes from igniting after drying, do not leave the dried clothes in the dryer or piled in a laundry basket.
How often should the duct be cleaned?
The two federal sources use different words, and this page prints both rather than merging them. The CPSC says to clean the dryer vent and exhaust duct periodically. The U.S. Fire Administration's dryer guidance sets the rhythm at once a year, by a professional. Either way, the answer is a rhythm, not a one-time fix — and a dryer that has started taking two cycles is telling you its turn has come, whatever the calendar says.
If the air path is clear and it still takes two cycles
Then the cause is inside the machine — in the heating or control parts — and that is repair work, not a home check. This page does not diagnose parts, and guessing at heating elements is how a lint problem turns into an electrical one. A qualified appliance service person is the next step, and telling them "the vent blows strong and the screen is clean" will save them time and you money.
General information only — not a substitute for a qualified service person's judgment about your dryer. If you ever smell burning, see smoke, or find clothes scorched, stop using the dryer until a qualified service person has checked it. The two federal sources below are the whole basis of this page, and they are worth reading in the original.
Sources
U.S. Consumer Product Safety Commission (CPSC), Publication 5022, "Overheated Clothes Dryers Can Cause Fires" (cpsc.gov): fires can occur when lint builds up in the dryer or the exhaust duct; lint can block the flow of air, cause excessive heat build-up, and result in a fire in some dryers; clean the lint screen/filter before or after drying each load of clothes; if clothing is still damp at the end of a typical drying cycle or drying requires longer times than normal, this may be a sign that the lint screen or the exhaust duct is blocked; clean the dryer vent and exhaust duct periodically, checking the outside vent while the dryer is operating to make sure exhaust air is escaping; to remove a blockage it may be necessary to disconnect the exhaust duct from the dryer, reconnecting it before using the dryer again; replace plastic or foil accordion-type ducting material with rigid or corrugated semi-rigid metal duct, which most manufacturers specify; clean behind the dryer where lint can build up; have a qualified service person clean the interior of the dryer chassis periodically; keep the area around the dryer clean and free of clutter; special care for clothes soiled with volatile chemicals such as gasoline, cooking oils, cleaning agents, or finishing oils and stains — wash more than once if possible, preferably hang to dry, otherwise use the lowest heat setting and a cycle with a cool-down period, and do not leave dried clothes in the dryer or piled in a laundry basket. Read in full November 7, 2026.
U.S. Fire Administration (USFA), "Appliance and Electrical Fire Safety" (usfa.fema.gov): "Failure to clean (31%)" was the leading factor contributing to the ignition of clothes dryer fires in homes from 2018–2020 (source: National Fire Incident Reporting System); always plug major appliances — refrigerators, stoves, washers and dryers — directly into a wall outlet, and never use an extension cord with a major appliance because the extension cord can overheat and start a fire. Read in full November 7, 2026. The once-a-year professional vent cleaning rhythm in the "How often" section is the USFA's standing dryer-safety guidance.
Checked November 7, 2026.
Related guides: Can a Home Test Kit Really Check Lead in Your Water, GFCI Outlet Keeps Tripping, Dryer Not Heating, Front-Load Washer Smells and Frozen Pipes.